Part Number Hot Search : 
2X006 T312012 BR10150 AL511 ASI10657 28010 APSS0 SAA710
Product Description
Full Text Search
 

To Download P502-00DC Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 PLL502-00
Multiplier VCXO IC Die for 12 to 25MHz Parallel Resonant Crystals
FEATURES
* * * * * * * Integrated voltage-controlled crystal oscillator circuitry (VCXO) (pull range 500ppm minimum). Low phase noise (-130dBc @ 10kHz offset at 44MHz output) Selectable frequency multipliers (x1, x2, x4, x8). 3.3V supply voltage. Uses inexpensive fundamental-mode parallel resonant crystals (from 12 to 25MHz). Selectable High Drive (30mA) or Standard Drive (10mA) output. Available in DIE (65 mil x 62 mil).
DIE CONFIGURATION
65 mil VDD VDD OE^ S0V S1V S2V
18
(1550,1475)
25
23
21
20
19
XIN
27
Die ID: A0707-07A
62 mil
13
XOUT
CLK
29
DESCRIPTION
The PLL502-00 is a monolithic low jitter and low phase noise (-130dBc @10kHz offset at 44MHz output), high performance CMOS VCXO IC Die, that uses a low cost crystal (12-25MHz). The same die can be used as a VCXO with output frequencies ranging from F XIN x 1 to F XIN x 8 using selector pad bonding options (see Multiplier Selection Table on this page). This makes the PLL502-00 ideal for a wide range of applications from 12MHz to 190MHz (including 27MHz, 35.328MHz, 77.76MHz and 155.52MHz, etc.).
VCON
31
C502A
10
GND
7
Y X
Note:
^ denotes internal pull up V denotes internal pull down
MULTIPLIER SELECTION
SELECTION S2 S1 S0 0 0 0 0 0 1 0 1 0 0 1 1 1 0 0 1 0 1 1 1 0 1 1 1 FXIN CLK (MHz) FXIN x 2 FXIN x 4 FXIN x 1 FXIN x 2* FXIN x 8 FXIN x 1* FXIN x 4* FXIN x 8*
BLOCK DIAGRAM
12MHz - 25MHz
XIN
VCXO
Selectable PLL
CLK
Note: - Selector pads default to `0', wire bond to VDD to set to `1' - (*) High-drive output
VCON
PAD DESCRIPTION
Name XIN XOUT Number 27 29 31 7,10 13 18,19,20 21,22,23 25 Description Crystal input connection. Crystal output connection. Voltage Control Input. Ground. Clock Output. Frequency selection pads 3.3V Power Supply. Output Enable: `0' to disable (tri-state output), 1' (default value when not connected) to enabled the output.
DIE SPECIFICATIONS
Name Value
VCON GND CLK S[0:2] VDD OE
Size Reverse side Pad dimensions Thickness
65 x 62 mil GND 80 micron x 80 micron 10 mil
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/17/04 Page 1
GND
(0,0)
PLL502-00
Multiplier VCXO IC Die for 12 to 25MHz Parallel Resonant Crystals
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings PARAMETERS
Supply Voltage Input Voltage, dc Output Voltage, dc Storage Temperature Ambient Operating Temperature* Junction Temperature Lead Temperature (soldering, 10s) ESD Protection, Human Body Model
SYMBOL
VDD VI VO TS TA TJ
MIN.
-0.5 -0.5 -65 -40
MAX.
4.6 VDD+0.5 VDD+0.5 150 85 125 260 2
UNITS
V V V C C C C kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other conditions above the operational limits noted in this specification is not implied. * Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
2. DC Electrical Specifications PARAMETERS
Supply Current, Dynamic, with Loaded Outputs Operating Voltage Output drive current (High Drive) Output drive current (Standard Drive) Short Circuit Current VCXO Control Voltage
SYMBOL
IDD VDD IOH IOL IOH IOL VCON
CONDITIONS
FXIN = 12 - 25MHz Output load of 10pF VOH= VDD-0.4V, VDD=3.3V VOL = 0.4V, VDD = 3.3V VOH= VDD-0.4V, VDD=3.3V VOL = 0.4V, VDD = 3.3V
MIN.
TYP.
16
MAX.
20 3.63
UNITS
mA V mA mA mA mA mA V
2.97 30 30 10 10 50 0
3.3
3. AC Electrical Specifications PARAMETERS
Input Crystal Frequency Output Clock Rise/Fall Time (Standard Drive) Output Clock Rise/Fall Time (High Drive) Output Clock Duty Cycle
SYMBOL
CONDITIONS
0.3V ~ 3.0V with 15 pF load 0.3V ~ 3.0V with 15 pF load Measured @ 50% VDD
MIN.
12
TYP.
2.4 1.2
MAX.
25
UNITS
MHz ns
45
50
55
%
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/17/04 Page 2
PLL502-00
Multiplier VCXO IC Die for 12 to 25MHz Parallel Resonant Crystals
4. Voltage Control Crystal Oscillator PARAMETERS
VCXO Stabilization Time * VCXO Tuning Range CLK output pullability VCXO Tuning Characteristic Pull range linearity VCON pin input impedance VCON modulation BW
SYMBOL
TVCXOSTB
CONDITIONS
From power valid FXIN = 12 - 25MHz; XTAL C0/C1 < 250 0V VCON 3.3V VCON=1.65V, 1.65V
MIN.
TYP.
MAX.
10
UNITS
ms ppm ppm ppm/V % k kHz
500 200 150 10 2000 25
0V VCON 3.3V, -3dB
Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits.
5. Crystal Specifications PARAMETERS
Crystal Resonator Frequency Crystal Loading Rating Crystal Pullability Recommended ESR
SYMBOL
FXIN CL (xtal) C0/C1 (xtal) RE
CONDITIONS
Parallel Fundamental Mode At VCON = 1.65V AT cut AT cut
MIN.
12
TYP.
9.5
MAX.
25 250 30
UNITS
MHz pF
Note: Crystal Loading rating: 9.5pF is the loading the crystal sees from the VCXO chip at VCON = 1.65V. It is assumed that the crystal will be at nominal frequency at this load. If the crystal requires more load to be at nominal frequency, the additional load must be added externally. This however may reduce the pull range.
6. Jitter and Phase Noise specification* PARAMETERS
RMS Period Jitter (1 sigma - 1000 samples) Phase Phase Phase Phase Phase Phase Phase Phase Phase Phase Noise Noise Noise Noise Noise Noise Noise Noise Noise Noise relative relative relative relative relative relative relative relative relative relative to to to to to to to to to to carrier carrier carrier carrier carrier carrier carrier carrier carrier carrier
CONDITIONS
at 77.76MHz, with capacitive decoupling between VDD and GND. at 155.52MHz, with capacitive decoupling between VDD and GND. 77.76MHz @100Hz offset 77.76MHz @1kHz offset 77.76MHz @10kHz offset 77.76MHz @100kHz offset 77.76MHz @1MHz offset 155.52MHz @100Hz offset 155.52MHz @1kHz offset 155.52MHz @10kHz offset 155.52MHz @100kHz offset 155.52MHz @1MHz offset
MIN.
TYP.
3.5
MAX.
UNITS
ps 4 -100 -123 -130 -125 -125 -95 -120 -128 -122 -120 dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz
* General condition: Control Voltage is 0V.
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/17/04 Page 3
PLL502-00
Multiplier VCXO IC Die for 12 to 25MHz Parallel Resonant Crystals
PAD ASSIGNMENT
Pad # Name X (m) Y (m) Description
7 10 13 18 19 20 21 23 25 27 29 31
GND GND CLK S2 S1 S0 VDD VDD OE XIN XOUT VCON
1042 1400 1400 1232 1042 854 659 459 194 109 109 109
109 259 716 1365 1365 1365 1365 1365 1365 1017 646 181
Ground. Ground. CMOS Clock Output. Used to select multiplication factor and Standard or High-Drive output. Internal pull down. Used to select multiplication factor and Standard or High-Drive output. Internal pull down. Used to select multiplication factor and Standard or High-Drive output. Internal pull down. 3.3V Power Supply. 3.3V Power Supply. Used to Enable/Disable the output. Internal pull up. See Crystal input. See Crystal Specifications on page 3. Crystal output. See Crystal Specifications on page 3. Voltage Control Input. 0V to 3.3V.
ORDERING INFORMATION For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following: Device number, Package type and Operating temperature range
PLL502-00 D C
PART NUMBER TEMPERATURE C=COMMERCIAL I=INDUSTRAL PACKAGE TYPE D=DIE
Order Number PLL502-00DC
Marking P502-00DC
Package Option Die (Waffle Pack)
PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information furnished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink's products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of PhaseLink Corporation. 47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 09/17/04 Page 4


▲Up To Search▲   

 
Price & Availability of P502-00DC

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X